Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptor
DTC 011: Accessory Inflator Valve CircuitDiagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
Accessory Inflator Valve Control | -- | 011 | -- | -- |
Accessory Inflator Valve B+ | 1 | 1 | -- | -- |
1. Accessory Inflator Fill Valve Inoperative | ||||
Circuit/System Description
The automatic level control sensor monitors the accessory inflator valve circuit for a open/high resistance circuit.
Conditions for Running the DTC
The ignition is ON.
Conditions for Setting the DTC
| • | Open in the control circuit of the accessory inflator valve. |
| • | A malfunctioning accessory inflator valve. |
Action Taken When the DTC Sets
| • | The automatic level control sensor disables inflator functions. |
| • | Leveling functions shall continue. |
| • | A malfunctioning accessory inflator valve. |
Conditions for Clearing the DTC
The conditions that caused the DTC to set have been removed.
Diagnostic Aids
When this DTC occurs, DTCs 032 and 033 will set.
Reference Information
Schematic Reference
Automatic Level Control Schematics
Connector End View Reference
Description and Operation
Automatic Level Control Description and Operation
Electrical Information Reference
Scan Tool Reference
Control Module References for scan tool information
Circuit/System Verification
Verify that automatic level control functions are disabled.
Circuit/System Testing
- Ignition OFF, disconnect the accessory inflator valve harness connector at the automatic level control sensor.
- Ignition ON, verify that a test lamp illuminates between the accessory inflator valve B+ circuit and ground.
- Ignition ON, connect a test lamp between the accessory inflator valve control circuit and the B+ circuit of the accessory inflator valve. Command the accessory inflator valve ON and OFF.
- If all circuits test normal, test or replace the automatic level control sensor.
| ⇒ | If the test lamp does not illuminate, test the B+ circuit for a short to ground or an open/high resistance. If the circuit tests normal, test or replace the automatic level control sensor. |
| ⇒ | If the test lamp does not illuminate, test the control circuit for a short to ground or open. If the circuit tests normal, test or replace the automatic level control sensor. |
| ⇒ | If the test lamp illuminates, test or replace the accessory inflator valve. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
Important: System untested code will continue to flash until self test has been completed after the automatic level control sensor replacement.
| • | Control Module References for automatic level control sensor replacement, setup, and programming |
