GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 Montana SV6 - AWD 🢒 Body 🢒 Doors 🢒 Rear Side Door Rear Edge In/Out Adjustment

Removal Procedure

    Important: By removing the power sliding door (PSD) 15A fuse, the low current logic power for both the LH and RH power sliding door modules (PSDM) will be interrupted and both PSDs will be inoperative.

  1. If equipped with a power sliding door, disable the PSD system by removing the PSD 15A fuse from the instrument panel (I/P) fuse block.
  2. Open the sliding door.

    3. Object Number: 1480538 Size: SH
  3. Loosen 2 screws on the rear door striker (2).
  4. Move the striker in and out in order to adjust the rear edge of the sliding door, as needed.
  5. Ensure the striker spacer plate (1) is in alignment with the striker plate (2) prior to securing the screws.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1480538 Size: SH
  1. Hand tighten the 2 sliding door rear striker screws.

    2. Tighten
    Tighten the sliding door rear striker screws, in sequence as shown, to 25 N·m (18 lb ft).

  2. Close the sliding door.
  3. Inspect the in/out adjustment of the sliding door.
  4. Re-adjust as needed.

    5. Important: By installing the 15A fuse, the low current logic power will be restored to both the LH and RH PSDMs and the PSDs will be operational. However, both PSDMs will have to learn the full open and full closed positions of the PSD. Refer to Rear Side Door Actuator Control Module Programming and Setup .

  5. If equipped with a power sliding door, enable the PSD system by installing the PSD 15A fuse into the I/P fuse block.