GM Service Manual Online
For 1990-2009 cars only

Step

Action

Yes

No

Schematic Reference: Door Lock/Indicator Schematics

Connector End View Reference: Power Door Systems Connector End Views

1

Did you review the Door Ajar Indicator Description and Operation?

Go to Step 2

Go to Symptoms - Doors

2

Verify that the door ajar indicator malfunction fault is present.

Does the door ajar indicator operate normally?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 3

3

Is the door ajar indicator inoperative?

Go to Step 4

Go to Step 7

4

  1. Turn ON the ignition, with the engine OFF.
  2. Probe the door ajar indicator control circuit of the instrument panel cluster (IPC) connector with a test lamp connected to a good ground.

Does the test lamp and the door ajar indicator illuminate?

Go to Step 5

Go to Step 9

5

Test the door ajar indicator control circuit of the appropriate door lock or sliding door jamb switch for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 6

6

Test the ground circuit of the appropriate door lock or sliding door jamb switch for an open. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

7

Test the door ajar indicator control circuit of the appropriate door lock or sliding door jamb switch for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 8

8

Inspect for poor connections at the harness connector of the appropriate door lock or sliding door jamb switch. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 10

9

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 12

Go to Step 11

10

Replace the appropriate door lock or sliding door jamb switch. Refer to Front Side Door Lock Replacement or Sliding Door Jamb Contact Plate Replacement .

Did you complete the replacement?

Go to Step 12

--

11

Replace the IPC. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 12

--

12

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2