GM Service Manual Online
For 1990-2009 cars only

Object Number: 1581196  Size: SF

Callout

Component Name

Caution: Replace the passenger presence system as a complete assembly to prevent possible injury to the occupant. All the components in the service kit are assembled and calibrated as a unit. Using only some of the components in the service kit will cause the passenger presence system to operate improperly.

Caution: To avoid personal injury, perform a preload test on the passenger presence system whenever you remove or replace the seat cushion trim. Failure to do so may cause the system to malfunction.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

  1. Remove the front seat. Refer to Driver and Passenger Seat Replacement .
  2. Remove the seat cushion cover. Refer to Seat Cushion Trim Cover and Pad Replacement .
  3. Re-zero the inflatable restraint passenger presence system whenever the seat cushion or any component of the passenger presence system is removed. Refer to Passenger Presence System Programming and Setup .
  4. Program the inflatable restraint passenger presence system after replacement. Refer to Control Module References .

1

Inflatable Restraint Front Passenger Presence System Assembly

Tip

    • The passenger presence system is an integral part of the pad on the passenger seat cushion.
    • The sensor, module and seat cushion pad must be replaced as a unit.
    • Note the routing of the wiring harness and connector location for installation.