Did you perform the Diagnostic System Check - Vehicle?

Go to Step 2

Go to Diagnostic System Check - Vehicle

Is the security indicator ON at all times?

Go to Step 3

Go to Step 4

Disconnect the body control module (BCM) connector containing the security indicator control circuit.

Does the security indicator remain illuminated?

Go to Step 5

Go to Step 7

1. Turn OFF the ignition.
2. Disconnect the BCM connector containing the security indicator control circuit.
3. Ground the security indicator control circuit with a fused jumper wire and appropriate terminal adapter.

Does the security indicator illuminate?

Go to Step 7

Go to Step 6

Test the security indicator control circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 8

Test the security indicator control circuit for an open or short to battery. Refer to Circuit Testing and Wiring Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 8

Inspect for poor connections at the harness connector of the BCM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 9

Inspect for poor connections at the harness connector of the instrument panel cluster (IPC). Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .

Did you find and correct the condition?

Go to Step 11

Go to Step 10

Replace the BCM. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 11

--

Replace the IPC. Refer to Control Module References for replacement, setup, and programming.

Did you complete the replacement?

Go to Step 11

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2