GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 Solstice 🢒 Diagnostic Navigation 🢒 Vehicle Diagnostic Information 🢒 Camshaft Position Sensor Replacement - Exhaust

Removal Procedure

    Object Number: 1826284 Size: SH
  1. Disconnect the engine wiring harness electrical connector (4) from the exhaust camshaft position (CMP) sensor.

    2. Object Number: 1578483 Size: SH
  2. Remove the CMP sensor bolt. (Intake CMP shown, exhaust CMP similar)
  3. Remove the CMP sensor.

Installation Procedure

    Object Number: 1578483 Size: SH

    Important: Inspect the CMP sensor for damage. Replace as necessary.

  1. Lubricate the CMP sensor O-ring seal with clean engine oil.

    2. Notice: Refer to Fastener Notice in the Preface section.

  2. Install the CMP sensor. (Intake CMP shown, exhaust CMP similar)
  3. Install the CMP sensor bolt.

    4. Tighten
    Tighten the bolt to 10 N·m (89 lb in).


    Object Number: 1826284 Size: SH
  4. Connect the engine wiring harness electrical connector (4) to the exhaust CMP sensor.