Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedure

Open the rear compartment lid in order to access the tail lamp screws.

1

Tail Lamp Assembly Screws (Qty: 2)

Tighten
2.5 N·m (40 lb in)

2

Locating Pins (Qty: 2)

Tip
Lift upward on the tail lamp assembly in order to release the tail lamp locating pins from the quarter filler panel.

3

Chassis Electrical Connector

Tip
Disconnect the electrical connector.

4

Quarter Filler Panel Nuts (Qty: 2)

Tip
Ensure the quarter filler panel nuts are not damaged. Replace if damaged.

5

Tail Lamp Assembly

Tip
Transfer the bulb into the new tail lamp.

6

Retainer Clips (Qty: 2)

Tip
Ensure clips are secure to the quarter filler panel.

Preliminary Procedure

Open the rear compartment lid in order to access the tail lamp screws.

1

Tail Lamp Assembly Screws (Qty: 2)

Tighten
2.5 N·m (22 lb in)

2

Chassis Electrical Connector

Procedure
Lift the tail lamp in order to disengage the retainer clips then disconnect the electrical connector.

3

Tail Lamp Assembly

Tip
Transfer the bulb into the new tail lamp.

4

Quarter Filler Panel Nuts (Qty: 2)

Tip
Ensure the quarter filler panel nuts are not damaged. Replace if damaged.