1

Nameplate Assembly, Rear Bumper Fascia

Tip

1. Clean the adhesive tape from the surface of the rear bumper fascia and dry thoroughly before applying the new emblem.
2. Peel the protective backing from the emblem and ensure no foreign matter or dirt comes in contact with the adhesive backing prior to installation.
3. Install the emblem and apply pressure to ensure full adhesion to the rear bumper fascia.

1

Emblem Assembly, Rear Bumper Fascia

Tip

1. Clean the adhesive tape from the surface of the rear bumper fascia and dry thoroughly before applying the new emblem.
2. Peel the protective backing from the emblem and ensure no foreign matter or dirt comes in contact with the adhesive backing prior to installation.
3. Install the emblem and apply pressure to ensure full adhesion to the rear bumper fascia.

1

Nameplate Assembly, Rear Bumper Fascia

Tip

1. Clean the adhesive tape from the surface of the rear bumper fascia and dry thoroughly before applying the new emblem.
2. Peel the protective backing from the emblem and ensure no foreign matter or dirt comes in contact with the adhesive backing prior to installation.
3. Install the emblem and apply pressure to ensure full adhesion to the rear bumper fascia.

Preliminary Procedures

1. Using a J 25070 Heat Gun, warm the exterior bumper fascia to a minimum of 21°C (70°F) to assist with the adhesive tape removal and installation of the new rear bumper fascia emblems.
2. Use a 50/50 mixture by volume of isopropyl alcohol and water in order to remove any adhesive tape residue from the rear bumper fascia after the emblems have been removed.

1

Rear Bumper Fascia Emblem Assembly

Tip
When removing the protective liners from the adhesive tape, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.

2

Rear Bumper Fascia Emblem Assembly (GT Turbo)

Tip
When removing the protective liners from the adhesive tape, be careful not to touch the tape with hands and do not allow the tape to come in contact with dirt or any foreign matter prior to adhesion.