WINDSHIELD WASHER SPRAY- PATTERN ADJUSTMENT

PRODUCTION CURRENTLY IS USING A TAPERED SHIM UNDER FLUIDIC WINDSHIELD WASHER NOZZLES ON SOME CARS TO CENTER THE SPRAY ON THE WINDSHIELD. THIS IS COVERED IN THE FISHER BODY SECTION OF THE SERVICE MANUAL. FLUIDIC WINDSHIELD WASHER NOZZLES WHICH SPRAY FLUID TOO LOW OR TOO HIGH ON THE WINDSHIELD CAN BE ADJUSTED USING WEDGE TYPE SHIMS. THESE SHIMS ARE TO BE INSTALLED AT THE NOZZLE MOUNTING BRACKET AND CAN BE OBTAINED THROUGH WDDGM. THE PART NUMBERS FOR THESE SHIMS ARE AS FOLLOWS: "A"SERIES 22512083 (-3 DEGREES) LOWERS SPRAY PATTERN 25512084 (+3 DEGREES) RAISES SPRAY PATTERN 25515467 (-6 DEGREES) LOWERS SPRAY PATTERN

"J"SERIES 10018029 FOR USE TO RAISE OR LOWER SPRAY PATTERN "F"SERIES 10017941 FOR USE EITHER WAY "B"SERIES 25509649 FOR USE EITHER WAY "X"SERIES 22512287 FOR USE EITHER WAY "E"SERIES 25509650 FOR USE EITHER WAY

IN THE EVENT THAT SHIM 25512083 (-3 DEGREES) DOES NOT LOWER THE SPRAY ENOUGH FOR THE DESIRED SPRAY PATTERN ON THE "A" SERIES , A NEW SHIM, PART NO. 25515467 (-6 DEGREES) HAS BEEN RELEASED. IF THERE APPEARS TO BE INADEQUATE WASHER SPRAY, THE HOSE ROUTING ON THE COWL VENT PANEL SHOULD BE CHECKED FOR KINKS OR OTHER CONDITIONS THAT COULD RESTRICT THE FLOW OF THE WASHER SOLVENT. "J"SERIES MAY HAVE SHIMS INSTALLED IN PRODUCTION.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.