Removal Procedure
- Remove the negative battery cable. Refer to
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.
in General Information. - Raise and support the vehicle. Refer to SECTION 0A.
- Remove the right splash shield.
- Remove the engine mount strut. Refer to Engine Mount Strut Replacement .
- Remove the A/C compressor with the lines attached and position it aside.
- Remove the transmission brace from the engine. Refer to Transmission Brace Replacement in Transmission.
- Remove the engine mount strut bracket bolts.
- Remove the engine mount bracket strut.
Installation Procedure
- Install the engine mount strut bracket and the bolts.
- Install the transmission brace to the engine. Refer to Transmission Brace Replacement in Transmission.
- Install the A/C compressor. Refer to SECTION 1B.
- Install the engine mount strut. Refer to Engine Mount Strut Replacement .
- Install the right splash shield.
- Lower the vehicle.
- Connect the negative battery cable.
Tighten
| • | Tighten the front bolts to 66 N·m (49 lb ft). |
| • | Tighten the front bolts to 75 N·m (55 lb ft). |
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
