Important: A short to ground will cause an open fuse(s). Before performing this diagnostic procedure, inspect the fuse(s) for an open.

Did you perform the theft deterrent diagnostic system check?

--

Go to Step 2

Go to Diagnostic System Check - Theft Deterrent

1. Turn the ignition switch to the RUN position.
2. Disconnect the PASSLOCK® lock cylinder connector.
3. Measure the voltage between the connector terminal A and terminal B.

Does the voltage equal the specified value?

B+

Go to Step 3

Go to Step 4

1. Turn the ignition switch to the RUN position.
2. Disconnect the PASSLOCK® lock cylinder connector.
3. Measure the voltage between the connector terminal B and terminal C.

Does the voltage equal the specified value?

5 V

Go to Step 5

Go to Step 4

Replace the instrument panel cluster. Refer to Instrument Cluster Replacement .

Did you complete the repair?

--

Go to Diagnostic System Check - Theft Deterrent

--

Replace the PASSLOCK® lock cylinder. Refer to Ignition Lock Cylinder Replacement - On Vehicle in Steering Wheel and Column.

Did you complete the repair?

--

Go to Diagnostic System Check - Theft Deterrent

--