Ignition Lock Cylinder Replacement - On Vehicle Without Key

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the supplemental inflatable restraints (SIR) system. Refer to Disabling the SIR System in SIR.
3. Remove the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .



4. Drill out the locking button (2) on the rear of the housing assembly (1) using an angle drill.



5. Remove the ignition lock cylinder (1) by pulling outward from the steering column.
6. Disconnect the electrical connector (3) from the ignition lock cylinder (1).

Important: Ensure that all the metal shavings are cleaned from the steering column and ignition housing assembly.

1. Connect the electrical connector (3) to the ignition lock cylinder (1).
2. Insert the ignition lock cylinder (1) into the housing assembly while rotating the key approximately 5 degrees counter - clockwise.
3. Install the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .
4. Enable the SIR system. Refer to Enabling the SIR System in SIR.
5. Connect the negative battery cable.
6. Perform the Passlock Learning Procedure. Refer to PASSLOCK Changing - Components Description in Theft Deterrent.

Ignition Lock Cylinder Replacement - On Vehicle With Key

Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Disable the supplemental inflatable restraints (SIR) system. Refer to Disabling the SIR System in SIR.
3. Remove the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .



4. Turn the ignition lock cylinder (1) to the RUN position.



5. Push the locking button (2) on the rear of the housing assembly (1).
6. Remove the ignition lock cylinder by pulling outward from the steering column.



7. Disconnect the electrical connector (3) from the ignition lock cylinder (1).

1. Connect the electrical connector (3) to the ignition lock cylinder (1).



2. Insert the ignition lock cylinder into the housing assembly (1) while rotating the key approximately 5 degrees counter - clockwise.
3. Install the steering column shrouds. Refer to Steering Column Trim Cover Replacement - On Vehicle .
4. Enable the SIR system. Refer to Enabling the SIR System in SIR.
5. Connect the negative battery cable.
6. Perform the Passlock Learning Procedure. Refer to PASSLOCK Changing - Components Description in Theft Deterrent.