For 1990-2009 cars only
Removal Procedure
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
- Remove the left front wheel and tire assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Remove the left front fender liner. Refer to Front Fender Liner Replacement in Body Front End.
- Install a jackstand and a block of wood to support the transaxle.
- Remove the expansion bolt from the transmission mount.
- Remove the four transmission mount bolts.
- Remove the mount.
Installation Procedure
- Transfer the mount bracket to the new mount.
- Position the mount and start the four bolts into the threads.
- Tighten the mount bolts.
- Install the mount expansion bolt.
- Remove the jackstand and the wood block.
- Install the left fender liner. Refer to Front Fender Liner Replacement in Body Front End.
- Install the left tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the bolts to 66 N·m (41 lb ft).
Tighten
Tighten the bolt to 55 N·m (41 ft lb).
