GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Sunfire 🢒 Body and Accessories 🢒 Seats 🢒 Driver or Passenger Seat Replacement

Removal Procedure

    Object Number: 605613 Size: SH
  1. Position the driver or the passenger front bucket seat forward or rearward in order to gain access to the seat adjuster attaching nuts (3).
  2. Remove the seat adjuster stud covers  (2) and seat adjuster nuts (3).
  3. Disconnect the seat belt wire harness on the driver's side.
  4. Remove the front bucket seat.

Installation Procedure

    Object Number: 605613 Size: SH
  1. Install the seat to the vehicle.
  2. Connect the seat belt wire harness on the driver's side.
  3. Position the seat fully forward to gain access to the seat adjuster rear nuts (3).
  4. Install the front bucket seat rear adjuster nuts (3).

    5. Hand tighten the nuts.

  5. Adjust the seat fully rearward.
  6. Verify both lock bars are engaged in the most forward adjustment in the same notch on both of the seat adjusters.

    7. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the front bucket seat front adjuster nuts (3).

    8. Tighten
    Tighten the nuts to 20 N·m (21 lb ft).

  8. Adjust the front bucket seat to the full forward position and tighten the rear adjuster nuts.

    9. Tighten
    Tighten the nuts to 20 N·m (21 lb ft).

  9. Install the seat adjuster stud covers (2).