GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2001 🢒 Sunfire 🢒 Body and Accessories 🢒 Data Link Communications 🢒 Radio Replacement

Removal Procedure

    Object Number: 804462 Size: SH
  1. Remove the instrument panel (I/P) accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.
  2. Remove the screws (2) from the radio.
  3. Remove the radio (3) from the I/P.
  4. Disconnect the electrical connections (4) and the antenna coaxial cable (1) from the radio.
  5. Remove the radio (3).

Installation Procedure

    Object Number: 804462 Size: SH
  1. Connect the electrical connections (4) and the antenna coaxial cable (1) to the radio.
  2. Install the radio (3) to the I/P.

    3. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  3. Install the screws (2) to the radio.

    4. Tighten
    Tighten the screws to 2.3 N·m (20 lb in).

  4. Install the I/P accessory trim plate. Refer to Instrument Panel Accessory Trim Plate Replacement in Instrument Panel, Gages and Console.
  5. Perform the radio setup. Refer to Radio Setup .