GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Place the drain pan under the transaxle oil pan.

  3. Object Number: 104466  Size: SH

    Notice: When removing the oil pan bolts, be careful not to damage the oil pan sealing surfaces. Such damage may result in oil leaks in this area.

  4. Remove the oil pan bolts from only the front and the sides.
  5. Loosen the rear oil pan bolts about 4 turns.
  6. Lightly tap the oil pan with a rubber mallet or pry in order to allow the fluid to drain.
  7. Remove the remaining oil pan bolts.

  8. Object Number: 104468  Size: SH
  9. Remove the oil pan.

  10. Object Number: 104471  Size: SH
  11. Remove the oil pan gasket.

Installation Procedure

  1. Clean and inspect the oil pan for dents or damage. Dry the oil pan before installation.

  2. Object Number: 104471  Size: SH
  3. Install the oil pan gasket. Use a new gasket if the sealing ribs are damaged.

  4. Object Number: 104468  Size: SH
  5. Install the oil pan. Replace the bottom pan, if damaged.
  6. Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 104466  Size: SH
  7. Install the oil pan attaching bolts.
  8. Tighten
    Tighten the bolts to 12 N·m (106 lb in).

  9. Lower the vehicle.
  10. Fill the transmission.
  11. Inspect the transmission fluid level. Refer to Transmission Fluid Check
  12. Inspect the oil pan gasket for leaks.