Tools Required

J 41352 Modular Column Holding Fixture

1. Install the ignition switch assembly.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the 2 tapping screws.

Tighten
Tighten the screws to 1.5 N·m (13 lb in).




3. Remove the steering column and J 41352 from the vise.
4. Install the steering column. Refer to Steering Column Replacement .
5. If necessary, install the multifunction switch. Refer to Multifunction, Turn Signal, and Hazard Switch Replacement - On Vehicle .
6. Install the tilt lever. Refer to Tilt Lever Replacement - On Vehicle .
7. Install the steering wheel. Refer to Steering Wheel Replacement .
8. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.