Circuit Description
When the ignition is turned ON, the inflatable restraint sensing and diagnostic module (SDM) compares the restraints ID that is stored in the SDM to the restraints ID that is stored in the body control module (BCM). The restraints ID that is being compared contains the last 4 digits of the SDM part number. Then, the SDM compares the VIN that is stored in the SDM to the VIN that is stored in the BCM. For more detailed information concerning the class 2 data lines, refer to Data Link Communications Description and Operation in Computer/Integrating Systems.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC B1001 Option Configuration Error
Conditions for Running the DTC
Ignition 1 voltage is within the normal operating voltage range.
Conditions for Setting the DTC
The restraints ID that is stored in the SDM does not match the restraints ID that is stored in the BCM or the VIN information that is stored in the SDM does not match the VIN information that is stored in the BCM.
Action Taken When the DTC Sets
| • | The SDM commands the AIR BAG indicator ON via class 2 serial data. |
| • | The SDM disables all deployment loops. |
Conditions for Clearing the DTC
The restraints ID that is stored in the SDM matches the restraints ID that is stored in the BCM and the VIN information that is stored in the SDM matches the VIN information that is stored in the BCM.
Diagnostic Aids
DTC B1001 is an indication that the restraints IDs stored in both the BCM and SDM do not match or that the VINs stored in both the BCM and SDM do not match. If either the BCM and/or powertrain control module (PCM) were replaced, the replacement modules need to be reprogrammed for proper operation.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests to see if the correct VIN is programmed in the PCM.
-
This step tests to see if the BCM has been replaced.
-
This step tests to see if the correct VIN is programmed in the BCM.
Step | Action | Yes | No |
|---|---|---|---|
1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle in Vehicle DTC Information |
Does the scan tool indicate that the PCM is programmed with the correct VIN? | Go to Step 4 | Go to Step 3 | |
3 | Use a scan tool and/or the techline machine to program the correct VIN into the PCM. Did you complete the action? | Go to Step 8 | -- |
Was the body control module (BCM) replaced? | Go to Step 6 | Go to Step 5 | |
With a scan tool, verify that the BCM is programmed with the correct VIN by comparing the VIN that is stored in the BCM to the VIN that is stored in the PCM. Does the scan tool indicate that the BCM is programmed with the correct VIN? | Go to Step 7 | Go to Step 6 | |
6 | Follow the instructions on the scan tool under BCM SPECIAL FUNCTIONS to properly reprogram the BCM. Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the action? | Go to Step 8 | -- |
7 | Replace the inflatable restraint sensing and diagnostic module (SDM). Refer to Control Module References in Computer/Integrating Systems for replacement, setup, and programming. Did you complete the replacement? | Go to Step 8 | -- |
8 |
Does the DTC reset? | Go to Step 2 | System OK |
