Circuit Description
The throttle body assembly contains the following components:
| • | The throttle blade |
| • | The throttle actuator motor |
| • | The throttle position (TP) sensor 1 and TP sensor 2 |
| • | The throttle actuator control (TAC) module |
The TAC system monitors throttle position. The throttle blade is spring loaded in both directions and at rest is slightly open. When the throttle blade is not driven in either direction it returns to this position. If the TAC module determines that the throttle blade has not returned to the correct de-energized position the TAC module sends a message to the powertrain control module (PCM) across serial data and DTC P2119 sets.
DTC Descriptor
This diagnostic procedure supports the following DTC:
DTC P2119 Throttle Closed Position Performance
Conditions for Running the DTC
| • | DTC U0107 is not set. |
| • | The ignition is ON and the engine is OFF. |
| • | The Ignition 1 Signal parameter is more than 8.5 volts. |
| • | The system is not in Battery Saver mode. |
Conditions for Setting the DTC
The TAC module detects that the throttle blade has not returned to the correct de-energized position.
Action Taken When the DTC Sets
| • | The control module stores the DTC information into memory when the diagnostic runs and fails. |
| • | The malfunction indicator lamp (MIL) will not illuminate. |
| • | The control module records the operating conditions at the time the diagnostic fails. The control module stores this information in the Failure Records. |
| • | The driver information center, if equipped, may display a message. |
Conditions for Clearing the DTC
| • | A current DTC Last Test Failed clears when the diagnostic runs and passes. |
| • | A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other non-emission related diagnostic. |
| • | Clear the DTC with a scan tool. |
Diagnostic Aids
Inspect for mechanical conditions or for binding that may be temperature related. Components may not move freely in extreme heat or cold due to the presence of contaminants or ice formation.
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: Engine Controls Schematics Connector End View Reference: Powertrain Control Module Connector End Views and Engine Controls Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 | Is DTC P1516, P2101 also set? | -- | Go to Step 3 | |
3 |
Does the scan tool indicate throttle position within the specified range? | 17-27% | Go to Step 6 | Go to Step 4 |
4 | Remove the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you find any obstructions preventing the throttle blade from returning to the default position? | -- | Go to Step 5 | Go to Step 6 |
5 | Remove the obstruction. Did you complete the repair? | -- | Go to Step 7 | -- |
6 | Replace the throttle body assembly. Refer to Throttle Body Assembly Replacement . Did you complete the replacement? | -- | Go to Step 7 | -- |
7 |
Did the DTC fail this ignition? | -- | Go to Step 2 | Go to Step 8 |
8 |
Important: Be aware that repairing 1 individual condition may correct more than 1 DTC. Observe the Capture Info with a scan tool. Are there any DTCs that have not been diagnosed? | -- | System OK | |
