Tools Required
• | J 45404
Transmission Indicator Alignment Tool |
- Remove the battery tray. Refer to
Battery Tray Replacement
.
- Shift the transaxle into neutral (N) position.
- Using the
J 36346
, remove the shift control cable from
the transaxle range switch lever.
- Loosen the transaxle range switch bolt (2) and stud (1).
- Install the
J 45404
to the
manual shaft and rotate the transaxle range switch until the neutral base line on the switch lines up with the indicator line on the
J 45404
.
Notice: Refer to Fastener Notice in the Preface section.
- Tighten the transaxle range switch bolt and stud.
Tighten
Tighten the bolt and stud to 25 N·m (18 lb ft).
- Remove the
J 45404
from the manual shaft.
- Install the shift control cable to the transaxle range switch lever.
- Install the battery tray. Refer to
Battery Tray Replacement
.
- After adjusting the transaxle range switch, verify the engine only starts in park (P) or neutral (N). If the engine starts in any other position, readjust the switch.