Diagnostic Instructions
| • | Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. |
| • | Review Strategy Based Diagnosis for an overview of the diagnostic approach. |
| • | Diagnostic Procedure Instructions provides an overview of each diagnostic category. |
DTC Descriptors
DTC B1288 01: Video Display Mode Control Signal Short to BatteryDTC B1288 02: Video Display Mode Control Signal Short to Ground
DTC B1288 04: Video Display Mode Control Signal Open
Diagnostic Fault Information
Circuit | Short to Ground | Open/High Resistance | Short to Voltage | Signal Performance |
|---|---|---|---|---|
DVD Display B+ | 1 | 1 | 1 | -- |
Radio ON Signal | 1 | 1 | 1 | -- |
Video Display Brightness Signal | B1289 02, * | B1289 04, * | B1289 01, * | -- |
Video Display Mode Control | B1288 02 | B1288 04 | B1288 01 | -- |
Video High Signal | 2 | 2 | 1 | -- |
Video Low Signal | 1 | 2 | 3 | -- |
DVD Display Ground | -- | 1 | -- | -- |
1. Video Entertainment System Inoperative. 2. Backlight only -- NO image shown. 3. Serious damage to radio can occur. *. Video Brightness can not be adjusted. | ||||
Circuit Description
The rear seat entertainment (RSE) system utilizes the vehicle radio to play DVD movies and transmit video signals to the rear digital video disc (DVD) display. When the radio is turned ON, the DVD display receives a voltage signal from the radio via the entertainment remote enable signal circuit indicating the system status. The video high and low signal circuits are used to transmit the DVD images to the rear DVD display. The video high (+) voltage will vary as the brightness and the speed of the image varies. A typical voltage reading for the video high (+) is 1 to 2.5V at the disconnected video display.
Conditions for Running the DTC
| • | Ignition ON. |
| • | Battery voltage must be between 9-16 volts. |
Conditions for Setting the DTC
Circuit failure 400 ms after radio activates Remote Enable.
Action Taken When the DTC Sets
The radio sets the DTC and defaults the video display to normal mode.
Conditions for Clearing the DTC
| • | The condition responsible for setting the DTC no longer exists. |
| • | A history DTC will clear once 100 consecutive malfunction-free ignition cycles have occurred. |
Reference Information
Schematic Reference
Video System SchematicsVideo System Schematics
Connector End View Reference
Entertainment/Communication Connector End Views
Description and Operation
Video Entertainment System Description and Operation
Electrical Information Reference
Scan Tool Reference
Circuit/System Testing
- Ignition OFF, disconnect the harness connector at the rear video display.
- Ignition ON, test for 100-300 Hz at the control circuit terminal 10.
- If all circuits test normal, replace the rear video display.
| ⇒ | If not within the specified range, test the control circuit for a short to voltage, short to ground, or an open/high resistance. If the circuit tests normal, replace the radio. |
Repair Instructions
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
| • | Control Module References for radio replacement, setup, and programming |
