Diagnostic Instructions
Circuit/System Description
When a keyless entry transmitter button is pressed, an RF signal is sent to the vehicle. The remote control door lock receiver (RCDLR) receives this RF signal by way of the keyless entry/tire pressure antenna. When the RF signal is received, the RCDLR
determines the specific command sent by the transmitter and relays this message to the body control module (BCM) via serial data. The BCM then performs the requested command.
Reference Information
Schematic Reference
Remote Function Schematics
Connector End View Reference
Remote Function Connector End Views
Description and Operation
Keyless Entry System Description and Operation
Electrical Information Reference
Scan Tool Reference
Special Tools Required
J 43241
Keyless Entry Tester
Circuit/System Testing
- Verify that the transmitter being used is a correct transmitter for the vehicle.
⇒ | If not the correct transmitter, replace the transmitter. |
- Place the transmitter on the test pad of the J 43241 and press each button of the transmitter one at a time. The tester should sound a tone and illuminate a green light when each button is pressed.
⇒ | If any of the buttons do not sound the tone and illuminate the green light, replace the transmitter battery. Retest with the J 43241. If the transmitter continues to malfunction, replace the affected transmitter. |
- Ignition ON, verify the scan tool Fob Programmed parameter for the transmitter being used is Yes.
- Press each transmitter button. Verify the scan tool Fob Function parameter for the transmitter being used responds to each button press.
⇒ | If the parameter does not respond, test the keyless entry antenna for an open/high resistance. If all circuits test normal, replace the RCDLR. |
- If all circuits test normal, replace the RCDLR.
Repair Instructions
Important: This vehicle may be equipped with the Advance 2 Way Remote Start System. Vehicle equipped with the Advance 2 Way Remote Start System can be identified by an LCD screen on the keyless entry transmitter or a yellow label
on the RCDLR. When servicing the Advance 2 Way Remote Start System, ensure that the correct parts are installed during replacement. Service parts for the Advance 2 Way Remote Start System can be found in the Accessory section of the parts manual.
Perform the
Diagnostic Repair Verification
after completing the diagnostic procedure.