|
Caution: Refer to Brake Dust Caution in the Preface section.
Notice: Support the brake caliper with heavy mechanic wire, or equivalent,
whenever it is separated from its mount and the hydraulic flexible brake hose is still connected. Failure to support the caliper in this manner will cause the flexible brake hose to bear the weight of the caliper, which may cause damage to the brake hose and
in turn may cause a brake fluid leak.
Preliminary Procedures
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
- Remove the tire and wheel. Refer to
Tire and Wheel Removal and Installation.
- Without disconnecting the brake caliper flexible hose, remove the brake caliper and support with heavy mechanics wire or equivalent. Refer to
Front Brake Caliper Replacement.
- Remove the brake pads.
|
1
| Brake Caliper Bracket Bolt (Qty: 2)
Notice: Refer to Fastener Notice in the Preface section.
Procedure
- If reusing the brake caliper bracket bolt, prepare the bracket bolt as follows:
| 1.1. | Thoroughly clean the threadlocker residue from the bracket bolt threads with denatured alcohol or equivalent and allow to dry. |
| 1.2. | Thoroughly clean the threadlocker residue from the caliper bracket threaded holes with denatured alcohol or equivalent and allow to dry. |
- Apply high-temperature, high-strength threadlocker to 2/3 of the threaded length of the brake caliper bracket bolt.
Ensure there are no gaps in the threadlocker along the length of the filled area of the bracket bolt.
- Allow the threadlocker to cure approximately 10 minutes before installing the bracket bolts.
Tighten
185 N·m (136 lb ft) |
