Exhaust Manifold Heat Shield Replacement - Right Side LNJ

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Remove the heat shield bolts (3).
3. Remove the lower heat shield (2) from the exhaust manifold.
4. Remove the upper heat shield (1) from the exhaust manifold.

1. Install the upper heat shield (1) to the exhaust manifold.
2. Install the lower heat shield (2) to the exhaust manifold.

Notice: Refer to Fastener Notice in the Preface section.

3. Install the heat shield bolts to the exhaust manifold.

Tighten
Tighten the bolts to 10 N·m (89 lb in).

4. Lower the vehicle.

Exhaust Manifold Heat Shield Replacement - Right Side LY7

Caution: Refer to Exhaust Service Caution in the Preface section.

Caution: Refer to Protective Goggles and Glove Caution in the Preface section.

1. Remove the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .
2. Disconnect the engine wiring harness electrical connector (3) from the heated oxygen sensor (HO2S) electrical connector (2).
3. Remove the HO2S electrical connector retainer from the camshaft cover.



4. Remove the exhaust manifold heat shield bolts.
5. Remove the exhaust manifold heat shield, sliding the shield up over the HO2S pigtail.

1. Install the exhaust manifold heat shield, sliding the shield down over the HO2S pigtail.

Notice: Refer to Fastener Notice in the Preface section.

2. Install the exhaust manifold heat shield bolts.

Tighten
Tighten the bolts to 10 N·m (89 lb in).




3. Connect the engine wiring harness electrical connector (3) to the HO2S electrical connector (2).
4. Install the HO2S electrical connector retainer to the camshaft cover.
5. Install the fuel injector sight shield, if necessary. Refer to Fuel Injector Sight Shield Replacement .