Exhaust Crossover Pipe Replacement LNJ

1. Remove the battery box. Refer to Battery Box Replacement.



2. Remove the exhaust crossover pipe nuts (2).
3. Remove the exhaust crossover pipe (3).
4. Remove the exhaust manifold studs (1), if replacement of the stud is necessary.

Caution: Refer to Fastener Caution in the Preface section.




1. Install any previously removed exhaust manifold studs (1) and tighten to 25 N·m (18 lb ft).
2. Install the exhaust crossover pipe (3).

Note: Maintain approximately 6.35 mm (0.25 in) between the thermostat housing and the exhaust crossover pipe.

3. Install the exhaust crossover pipe nuts (2) and tighten to 25 N·m (18 lb ft).
4. Install the battery box. Refer to Battery Box Replacement.