Special Tools

J 45059 Angle Meter

For equivalent regional tools, refer to Special Tools.

1. Ensure the cylinder head locating pins are securely mounted in the cylinder block deck face.



2. Install a NEW right cylinder head gasket using the deck face locating pins for retention.



3. Align the right cylinder head with the deck face locating pins.
4. Place the right cylinder head in position on the deck face.

Caution: Refer to Fastener Caution in the Preface section.





Note: DO NOT allow oil on the cylinder head bolt bosses.

Note: DO NOT reuse the old cylinder head bolts.

5. Install the NEW M11 cylinder head bolts (1) and tighten.

5.1.	The M11 cylinder head bolts a first pass in sequence to 30 N·m (22 lb ft).

5.2.	The M11 cylinder head bolts a second pass in sequence an additional 150 degrees using the J 45059 meter .

6. Install the NEW M8 cylinder head bolt (2) and tighten.

6.1.	The M8 cylinder head bolt a first pass to 15 N·m (11 lb ft).

6.2.	The M8 cylinder head bolt a second pass an additional 75 degrees using the J 45059 meter .