GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 Torrent 🢒 Power and Signal Distribution 🢒 Data Communications 🢒 Engine Control Module Programming and Setup

Engine Control Module Programming and Setup V6

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement and Reprogramming

If the engine control module (ECM) is replaced or reprogramed, the following procedures must be performed:

  1. ECM Reprogramming--Refer to Service Programming System (SPS).
  2. Idle Learn Procedure--Refer to Throttle Learn.
  3. Theft Deterrent--Refer to Immobilizer System Component Programming. The ECM will learn the incoming fuel continue password immediately upon receipt of a password message. Once a password message is received, and a password is learned, a learn procedure must be performed to change this password again. An ECM which has been previously installed in another vehicle will have learned the other vehicle's fuel continue password, and will require a learn procedure after programming to learn the current vehicle's password.
  4. Engine Oil Life Remaining--When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
  5. Transmission Fluid Life Remaining--When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, an Idle Learn Procedure must be performed. Refer to Throttle Learn.

    • Throttle body assembly
    • ECM

Engine Control Module Programming and Setup LNJ

The following service procedures require either a programming or a setup event performed for a complete repair.

ECM Replacement

If the engine control module (ECM) is replaced, the following procedures must be performed:

  1. ECM Reprogramming--Refer to Service Programming System (SPS) .
  2. The CKP System Variation Learn--Refer to Crankshaft Position System Variation Learn .
  3. Engine Oil Life Remaining--When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was replaced.
  4. Transmission Fluid Life Remaining--When available, use the scan tool to reset the Transmission Fluid Life Remaining back to the original percentage recorded before the module was replaced.
  5. Theft Deterrent--Refer to Immobilizer System Component Programming .

ECM Reprogramming
    • If the ECM needs to be reprogrammed, refer to Service Programming System (SPS) .
    • Engine Oil Life Remaining--When available, use a scan tool to reset the Engine Oil Life Remaining back to the original percentage recorded before the module was reprogrammed.

       Important: After programming, perform the following to avoid future misdiagnosis:

    • Turn the ignition OFF for 30 seconds.
    • Turn the ignition ON with the engine OFF.
    • Use the scan tool in order to retrieve history DTCs from all modules.
    • Clear all history DTCs.

Setup for Component Replacement

The replacement of some components will require a setup procedure for complete repair.

If any of the following components are replaced, the CKP Variation Learn Procedure must be performed. Refer to Crankshaft Position System Variation Learn .

    • Engine replacement
    • Any engine repair that disturbs the CKP sensor or its relationship with the crankshaft reluctor wheel
    • CKP sensor

If the throttle body is cleaned or replaced, the Throttle Learn procedure must be performed. Refer to Throttle Learn.