SER. MANUAL UPDATE-SEC.8C INSTRUMENT PANEL & GAUGES

Subject: SERVICE MANUAL UPDATE - SECTION 8C INSTRUMENT PANEL AND GAUGES (CORRECT REMOVAL AND INSTALLATION PROCEDURE)

Models Affected: 1990 TRANS SPORT

The following procedure is the correct Removal and Installation of I/P Trim Pad for the 1990 Trans Sport models. This procedure replaces the existing procedure found on the following pages:

1990 PONTIAC TRANS SPORT Page 8C-12 Figure 22

I/P Pad Assembly

A. REMOVE OR DISCONNECT

1. Side window defroster vent grilles (2), to access retaining screws (2).

2. I/P trim pad retaining screws (4) two at top of I/P cluster, two through glove compartment (View A).

3. Daytime running lamp sensor from LH speaker grille (FOR CANADA ONLY).

4. Lift I/P pad up and pull rearward to disengage retaining tabs at front of pad.

5. I/P pad assembly from vehicle.

B. INSTALL OR CONNECT

1. Position I/P pad to lower I/P pad, push to engage retaining tabs.

2. Daytime running lamp sensor to LH speaker grille (CANADA ONLY).

3. I/P trim pad retaining screws (4) two at top I/P cluster, two through glove compartment (View A).

4. Retaining screws at side window defroster outlets and grilles.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.