SER. MANUAL UPDATE-SEC.8C INSTRUMENT PANEL & GAUGES

SUBJECT: MANUAL UPDATE - SECTION 8C INSTRUMENT PANEL AND GAUGES (CORRECT REMOVAL AND INSTALLATION PROCEDURE

VEHICLES AFFECTED: 1990 U VAN

The following procedure is the correct Removal and Installation of I/P Trim Pad for the 1990 U-van. This procedure replaces the existing procedure found on the following pages:

1990 CHEVROLET LUMINA APV 8C Page 12 to 8C-13 - Figure 22

Instrument Panel Pad Assembly

A. Remove or Disconnect

1. I/P cluster housing and cluster assembly, refer to Section 8C of the 1990 Service Manual.

2. Side window defroster vent grilles (2), to access retaining screws (2).

3. I/P pad retaining screws (4), two through glove compartment (View A), two at I/P Cluster base.

4. Daytime running lamp sensor from LH speaker grille (CANADA ONLY)

5. Lift I/P pad up and pull rearward to disengage retaining tabs at front of pad.

6. I/P pad assembly from vehicle.

INSTALL OR CONNECT

1. Position I/P pad to lower I/P pad assembly, push to engage retaining tabs at front of pad.

2. Daytime running lamp sensor to LH speaker grille (CANADA ONLY).

3. I/P pad retaining screws (4) two at I/P cluster base, two through glove compartment (View A).

4. Retaining screws at side window defroster outlets and defroster grilles.

5. I/P cluster assembly and housing, refer to Section 8C in the 1990 Service Manual.

1990 PONTIAC TRANS SPORT Page 8C-12 Figure 22

I/P Assembly

A. REMOVE OR DISCONNECT

1. Side window defroster vent grilles (2), to access retaining screws (2).

2. I/P trim pad retaining screws (4) two at top of I/P cluster, two through glove compartment (View A).

3. Daytime running lamp sensor from LH speaker grille (PONTIAC VEHICLE ONLY, FOR CANADA ONLY).

4. Lift I/P pad up and pull rearward to disengage retaining tabs at front of pad.

5. I/P pad assembly from vehicle.

b. INSTALL OR CONNECT

1. Positon I/P pad to lower I/P pad, push to engage retaining tabs.

2. Daytime running lamp sensor to LH speaker grille (PONTIAC VEHICLE ONLY, FOR CANADA ONLY).

3. I/P trim pad retaining screws (4) two at top of cluster, two through glove compartment (View A).

4. Retaining screws at side window defroster outlets and grilles.

General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.