GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1997 🢒 Trans Sport 🢒 Engine 🢒 Engine Mechanical - 3.1L and 3.4L 🢒 Oil Pump Drive Replacement

Removal Procedure
  1. Remove the upper intake manifold. Refer to Upper Intake Manifold Replacement .
  2. Remove the fuel feed and return pipe from the fuel injector rail. Refer to Engine Controls.

    3. Object Number: 62736 Size: MH
  3. Remove the oil pump drive bolt.
  4. Remove the oil pump drive clamp.
  5. Remove the oil pump drive.
  6. Remove the oil pump drive seal.

Installation Procedure

    Object Number: 62736 Size: MH
  1. Install the oil pump drive seal. Coat the seal or bore in the engine block with engine oil.
  2. Install the oil pump drive. Coat the drive gear on the drive with prelube GM P/N 1052365 or equivalent for a full 360 degrees.
  3. Install the oil pump drive clamp.
  4. Install the oil pump drive bolt.

    5. Tighten
    Tighten the bolt to 36 N·m (27 lb ft).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  5. Install the fuel feed and return pipe to the fuel injector rail. Refer to Engine Controls.
  6. Install the upper intake manifold. Refer to Upper Intake Manifold Replacement .