GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 35468 Oil Seal Installer


    Object Number: 54386  Size: SH
  1. Install the front cover oil seal using the J 35468 .

  2. Object Number: 54378  Size: SH
  3. Install the crankshaft position sensor.
  4. Install the crankshaft position sensor screws.
  5. Tighten
    Tighten the crankshaft position sensor screws to 10 N·m (89 lb in).

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 54303  Size: SH
  6. Install the water pump gasket.
  7. Install the water pump.
  8. Install the water pump bolts.
  9. Tighten
    Tighten the water pump bolts to 10 N·m (89 lb in).


    Object Number: 54296  Size: SH
  10. Install the water pump pulley.
  11. Install the water pump pulley bolts.
  12. Tighten
    Tighten the water pump pulley bolts to 25 N·m (18 lb ft).