For 1990-2009 cars only
Disabling Zone 7
- Turn the steering wheel so that the vehicle's wheels are pointing straight ahead.
- Turn the ignition switch to the OFF position.
- Locate and remove the AM2 Fuse from the junction block (1), which is located near the base of the steering column.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Release and unlock the driver and passenger seat module connectors (1).
- Disconnect the driver and passenger seat modules.
Important: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
Enabling Zone 7
- Install the yellow 2-way connectors to the driver and passenger seat modules (1).
- Connect the connectors and lock the connectors with the connector lock levers.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Install the AM2 Fuse into the junction block (1).
- Use caution while reaching in and turn the ignition switch to the ON position.
- The AIR BAG indicator will flash then turn OFF.
- Perform the SIR Diagnostic System Check if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - SIR .
