GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2004 🢒 Vibe - AWD 🢒 Transmission/Transaxle 🢒 Clutch 🢒 Clutch Pedal Replacement

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Disconnect the negative battery cable.
  2. Remove the Lower Instrument Panel. Refer to Instrument Panel Lower Trim Panel Replacement .

    3. Object Number: 885330 Size: SH
  3. Remove the clevis clip and the pin.
  4. Disconnect the Clutch Pedal Position (CPP) switch electrical connector.
  5. Disconnect the Cruise Control Release (CCR) switch electrical connector.

    6. Object Number: 885331 Size: SH
  6. Remove the 2 pedal assembly bracket retaining nuts and the 1 retaining bolt.
  7. Remove the clutch pedal assembly from the vehicle.

Installation Procedure
  1. Position the clutch pedal assembly in the vehicle.
  2. Connect the CPP switch electrical connector.
  3. Connect the CCR switch electrical connector.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.


    Object Number: 885331 Size: SH
  4. Install the 2 clutch pedal retaining nuts and 1 bolt.

    5. Tighten

        • Tighten the retaining nuts to 12 N·m (106 lb in).
        • Tighten the retaining bolt to 19 N·m (14 lb ft).

    Object Number: 885330 Size: SH
  5. Install the clevis clip and the pin.
  6. Install the Lower Instrument Panel. Refer to Instrument Panel Lower Trim Panel Replacement .
  7. Connect the negative battery cable.