For 1990-2009 cars only
Removal Procedure
- Disable the SIR System. Refer to SIR Disabling and Enabling in SIR.
- Remove the front side door sill trim plate. Refer to Door Sill Plate Replacement .
- Remove the rear door sill trim plate. Refer to Door Sill Plate Replacement .
- Remove the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Remove the seat shoulder belt guide adjuster (1) trim cover and the bolt.
- Position the belt (2) on the floor.
- Remove the center pillar upper trim panel (2) by gently pulling loose.
Caution: Refer to SIR Caution in the Preface section.
Installation Procedure
- Install the center pillar upper trim panel (2), by pushing in until tab (1) fastens.
- Install the seat shoulder belt guide adjuster (1) bolt.
- Install the seat shoulder belt guide trim cover.
- Install the center pillar lower trim panel. Refer to Center Pillar Lower Trim Panel Replacement .
- Install the front side door sill trim plate (1) to the vehicle. Refer to Door Sill Plate Replacement .
- Install the rear side door sill trim plate. Refer to Door Sill Plate Replacement .
- Enable the SIR System. Refer to SIR Disabling and Enabling in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the adjuster bolt to 42 N·m (31 lb ft).
