For 1990-2009 cars only
- Fill the power steering fluid reservoir to the COLD MIN mark (5).
- Raise the vehicle until the front wheels are off the ground. Refer to Lifting and Jacking the Vehicle .
- Turn the ignition switch to the ON position with the engine OFF.
- Rotate the steering wheel from full left to full right 10 to 12 times.
- Verify the fluid level is correct. Adjust the fluid level if necessary.
- Start the engine. Allow the engine to idle.
- Listen for power steering pump noise like whining or cavitation. Inspect the power steering fluid for aeration. If necessary, refer to Power Steering Fluid Leaks .
- Verify the fluid level is correct. Refer to Checking and Adding Power Steering Fluid .
- Repeat the bleeding procedure if necessary.
- Turn the engine off.
- Lower the vehicle.
Notice: Refer to Air in the Power Steering System Notice in the Preface section.
Notice: Refer to Using Proper Power Steering Fluid Notice in the Preface section.
Important:
• Use clean, new power steering fluid only. Refer to
Fluid and Lubricant Recommendations
. • Hoses touching the frame, body, or engine may cause system noise. Verify the hoses do not touch any other part of the vehicle. • Loose connections may not leak, but could allow air into the steering system. Verify that all hose connections are tight. • Maintain the power steering fluid level throughout the bleeding procedure.
