Rear Wheel Bearing and Hub Replacement AWD

1. Remove the rear knuckle. Refer to Knuckle Replacement .



2. Remove the dust deflector (2).



3. Remove the 4 bolts (2,3,4,5).
4. Remove the wheel bearing and hub assembly.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the wheel bearing and hub assembly and the 4 bolts (2,3,4,5).

Tighten
Tighten the bolts to 56 N·m (41.3 lb ft).

2. Use a hydraulic press in order to install a NEW dust deflector.
3. Install the rear knuckle. Refer to Knuckle Replacement .

Rear Wheel Bearing and Hub Replacement FWD

1. If the vehicle has rear drum brakes, remove the brake drum. Refer to Brake Drum Replacement .

If the vehicle has rear disc brakes, remove the rear brake rotor. Refer to Rear Brake Rotor Replacement .




2. If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.
3. Remove the 4 bolts (1, 2, 4, 5).
4. Remove the wheel bearing and hub assembly.

Notice: Refer to Fastener Notice in the Preface section.




1. Install the wheel bearing and hub assembly and the 4 bolts (1, 2, 4, 5).

Tighten
Tighten the bolts to 61 N·m (45.0 lb ft).

2. If the vehicle has ABS, connect the rear wheel speed sensor connector (3).
3. If the vehicle has rear drum brakes, install the brake drum. Refer to Brake Drum Replacement .

If the vehicle has rear disc brakes, install the rear brake rotor. Refer to Rear Brake Rotor Replacement .

4. If the vehicle has ABS, perform the vehicle system check. Refer to Diagnostic System Check - Vehicle .