GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2005 🢒 Vibe - FWD 🢒 Body 🢒 Seats 🢒 Front Seat Replacement - Bucket

Removal Procedure

    Caution: Refer to SIR Caution in the Preface section.


    Object Number: 241532 Size: SH
  1. Disable the SIR system, if equipped with side impact inflatable restraint modules. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling in SIR.
  2. Disconnect the side impact inflatable restraint module electrical connector (1), if equipped. The electrical connector is located beneath the seat cushion.

    3. Object Number: 815854 Size: SH
  3. Remove the following components from the vehicle:
    4. • The seat bolt finish covers
    • The 4 bolts
    • The front seat assembly

Installation Procedure

    Object Number: 815854 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the front seat assembly to the vehicle. Secure the seat with the 4 bolts.

    2. Tighten
    Tighten the front seat assembly bolts to 47 N·m (35 lb ft).

  2. Install the seat bolt finish covers.

    3. Object Number: 241532 Size: SH
  3. Connect the side impact inflatable restraint module electrical connector (1), if equipped.
  4. Enable the SIR system, if disabled. Refer to SIR Disabling and Enabling and to SIR Disabling and Enabling in SIR.
  5. Perform the Passenger Presence Rezeroing procedure. Refer to Passenger Presence System Rezeroing in SIR.