For 1990-2009 cars only
Disabling Zone 12
- Turn the steering wheel so that the vehicle wheels are pointing straight ahead.
- Turn the ignition switch to the OFF position.
- Locate and remove the AM2 fuse from the junction block (1), which is located near the base of the steering column.
- Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Remove the rear door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
- Remove the rear seat garnish molding. Refer to Body Side Rear Garnish Molding Replacement .
- Disconnect the side impact sensor (SIS) electrical connector.
Important: With the SIR fuse removed and the ignition switch in the ON position, the AIR BAG warning indicator illuminates. This is normal operation, and does not indicate an SIR system malfunction.
Enabling Zone 12
- When enabling the SIS or seat belt pretensioner go to step 2, if the left roof rail module needs enabling go to step 7.
- Connect the SIS electrical connector.
- Install the rear seat garnish molding. Refer to Body Side Rear Garnish Molding Replacement .
- Install the rear door sill plate. Refer to Door Sill Plate Replacement in Interior Trim.
- Connect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
- Install the AM2 fuse into the junction block (1).
- Use caution while reaching in and turn the ignition switch to the ON position.
- The AIR BAG indicator will flash then turn OFF.
- Perform the Diagnostic System Check - Vehicle if the AIR BAG warning indicator does not operate as described. Refer to Diagnostic System Check - Vehicle .
