GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 Vibe - FWD 🢒 Engine 🢒 Engine Electrical 🢒 Cruise Control Servo Replacement

Removal Procedure

    Object Number: 844775 Size: SH
  1. Disengage the 2 tabs (2) on the cruise control cover (1).
  2. Remove the cruise control servo cover (1).

    3. Object Number: 844777 Size: SH
  3. Loosen the accelerator control cable locknuts (2).
  4. Remove the following components from the cruise control servo:
    5. • The cruise control servo cable bracket screw (5)
    • The cruise control servo cable (4)
    • The accelerator control cable (3)

    Object Number: 844781 Size: SH
  5. Disconnect the cruise control servo electrical connector (3).
  6. Remove the following components from the vehicle:
    7. • The 2 cruise control servo mounting bolts (2)
    • The cruise control servo (1) with the bracket attached

Installation Procedure

    Object Number: 844781 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the cruise control servo (1) and bracket to the vehicle. Secure the servo and bracket with the 2 bolts (2).

    2. Tighten
    Tighten the cruise control servo mounting bolts to 6.0 N·m (52 lb in).

  2. Connect the cruise control servo electrical connector (3).

    3. Object Number: 844777 Size: SH
  3. Install the cruise control servo cable (4) to the servo lever (1) and bracket. Secure the cruise control cable servo cable bracket with the one screw (5).
  4. Install the accelerator control cable (3) to the servo lever (1) and bracket.
  5. Adjust the cable adjusting locknuts (2) to allow slight freedom of movement between the accelerator control cable (3) and the servo lever (1).
  6. Secure the accelerator cable locknuts (2).

    7. Tighten
    Tighten the accelerator cable adjusting locknuts to 8 N·m (71 lb in).


    Object Number: 844778 Size: SH
  7. Install the cruise control servo cover (1) make sure the tabs (2) snap in place.