Tools Required

The cause of most transaxle oil leaks can usually be located with the transaxle in the vehicle. The transaxle case components are constructed of aluminum and separated into the following pieces:

If a leak exists between the left case and the right case, remove the transaxle from the vehicle in order to repair the leak. Most other leaks may be repaired with the transaxle in the vehicle. Use the following methods in order to locate manual transaxle oil leaks:

1. Verify that the leak is transaxle oil.
2. Thoroughly clean the suspected leak area.
3. Drive the vehicle for 24 km (15 mi) or until normal operating temperatures are reached.
4. Park the vehicle over clean paper or cardboard.
5. Turn the ignition switch to the OFF position and wait for approximately 30 minutes.
6. Inspect the paper for spots in relation to the paper's position under the transaxle assembly.
7. Perform the necessary repairs.

1. Thoroughly clean the suspected leak area with solvent.
2. Apply an aerosol powder or baby powder to the suspected leak area.
3. Drive the vehicle for 24 km (15 mi) or until the normal operating temperatures are reached.
4. Turn the ignition switch to the OFF position.
5. Inspect the suspected leak area and trace the leak path through the powder in order to identify the leak source.
6. Perform the necessary repairs.

1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
2. Add 30 ml (1 oz) of J 28431-6 into the transaxle oil lever/filler plug.
3. Lower the vehicle.
4. Drive the vehicle for 24 km (15 mi) or until normal operating temperatures are reached.
5. Turn the ignition switch to the OFF position.
6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
7. Use the J 28428-E in order to locate the source of the leak.
8. Perform the necessary repairs.