Removal Procedure
- Remove the transmission. Refer to
Transmission Replacement
.
- Remove the torque converter (1) from transmission.
- Remove the following from the torque converter:
| 3.1. | The torque converter seal bolts. |
| 3.2. | The torque converter seal. |
- Remove the input shaft seal from input shaft .
Installation Procedure
- Install the Input shaft seal to input
shaft.
- Install the following to the torque converter:
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
| 2.1. | Install the torque converter seal to transmission. |
| 2.2. | Install the converter seal bolts to transmission. |
Tighten
Tighten the torque converter seals bolts to 3 N·m (26 lb in).
- Install the torque converter (1) to the transmission. Push the torque
converter into position while rotating. The torque converter must be fully
seated.
- Install the transmission. Refer to
Transmission Replacement
.
