GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2007 🢒 Vibe - FWD 🢒 Power and Signal Distribution 🢒 Wiring Systems and Power Management 🢒 Rear Wheel Bearing and Hub Replacement

Removal Procedure
  1. Remove the brake drum. Refer to Brake Drum Replacement .

    2. Object Number: 829423 Size: SH
  2. If the vehicle has ABS, disconnect the rear wheel speed sensor connector (3). Position the connector to the side.
  3. Remove the 4 bolts (1, 2, 4, 5).
  4. Remove the wheel bearing and hub assembly.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 829423 Size: SH
  1. Install the wheel bearing and hub assembly and the 4 bolts (1, 2, 4, 5).

    2. Tighten
    Tighten the bolts to 61 N·m (45.0 lb ft).

  2. If the vehicle has ABS, connect the rear wheel speed sensor connector (3).
  3. Install the brake drum. Refer to Brake Drum Replacement .
  4. If the vehicle has ABS, perform the vehicle system check. Refer to Diagnostic System Check - Vehicle .