For 1990-2009 cars only
Removal Procedure
- Disable the SIR system. Refer to SIR Disabling and Enabling .
- Place the front wheels in the straight ahead position.
- Remove the steering wheel from the steering column. Refer to Steering Wheel Replacement .
- Remove the three screws and the steering column lower trim cover (6) from the steering column.
- Disconnect the steering wheel module coil electrical connector (1).
- Slide the steering column upper cover, release the 3 claws (2) and remove the steering wheel module coil (1).
Caution: Refer to SIR Caution in the Preface section.
Important: In the event deployment has occurred, inspect the steering wheel module coil wire for any sign of scorching, melting, or other damage due to excessive heat. If the coil is damaged, replace it.
Installation Procedure
- Ensure the front wheels are in the straight ahead position.
- Place turn signal switch in neutral position.
- Install the steering wheel module coil (1), engage all 3 retaining claws (2).
- Center the steering wheel module coil, if necessary. Refer to Inflatable Restraint Steering Wheel Module Coil Centering.
- Connect the steering wheel module coil electrical connector (1).
- Install the steering column lower trim cover (6). Secure with three screws.
- Install the steering wheel. Refer to Steering Wheel Replacement.
- Enable the SIR system. Refer to SIR Disabling and Enabling .
Important: Make sure the turn signal switch is in the neutral position or turn signal switch pin may be damaged.
Important: When installing a new steering wheel module coil, remove the lock pin prior to installing the handle.
