Removal Procedure
- Install the engine support fixture. Refer to Engine Support Fixture for the 1.8L (LV6) engine.
- Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the left hand splash shield. Refer to Engine Splash Shield Replacement - Left Side.
- Remove the right hand splash shield. Refer to Engine Splash Shield Replacement - Right Side.
- Remove the 2 bolts from the front transaxle mount.
- Remove the front transaxle mount through bolt
- Remove the insulator to the mount bracket.
- Remove the 2 front transaxle bracket bolts and bracket from the transaxle.
Installation Procedure
- Install the front transaxle bracket and bolts.
- Install the insulator to the mount bracket.
- Install the front transaxle mount through bolt.
- Install the 2 bolts to the front transaxle mount.
- Install the left hand splash shield. Refer to Engine Splash Shield Replacement - Left Side.
- Install the right hand splash shield. Refer to Engine Splash Shield Replacement - Right Side.
- Lower the vehicle.
- Remove the engine support fixture.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the transaxle bracket bolts to 64 N·m (47 lb ft).
Tighten
Tighten the transaxle mount through bolt to 52 N·m (38 lb ft).
Tighten
Tighten the front transaxle mount bolts to 39 N·m (29 lb ft).
