GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2008 🢒 Vibe - FWD 🢒 Preface 🢒 Cautions and Notices 🢒 Rear Window Washer Hose Replacement - Pump to Endgate

Removal Procedure
  1. Remove the right wheelhouse panel. Refer to Wheelhouse Panel Replacement .
  2. Remove the right hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  3. Remove the right lower center pillar molding. Refer to Center Pillar Lower Trim Panel Replacement .
  4. Remove the right rear upper quarter trim panel. Refer to Quarter Upper Trim Panel Replacement .
  5. Remove the rear dome lamp. Refer to Dome Lamp Replacement .

    6. Object Number: 853427 Size: SH
  6. Remove the 2 push in retainers (2) from the rear of the headliner (1).

    7. Object Number: 858516 Size: SH
  7. Disconnect the rear washer hose (9) from the rear washer pump.
  8. Remove the rear washer hose end (9) out through the rubber conduit opening (12) under the right side of the instrument panel.
  9. Pull the rear edge of the headliner down to gain access to the rear washer hose (9).
  10. Disconnect the rear washer hose (9) from the washer nozzle hose (4).
  11. Remove the rear washer hose (9) from inside of the rear roof panel.
  12. Remove the rear washer hose (9) from the vehicle.

Installation Procedure
  1. Position the rear washer hose (9) to the inner right side of the vehicle.

    2. Object Number: 858516 Size: SH
  2. Route the rear washer hose (9) through the inside of the rear roof panel.
  3. Connect the rear washer hose (9) to the rear washer nozzle hose (4).
  4. Position the rear washer hose to the right rear quarter panel area and secure with tape.
  5. Position the rear washer hose to the right sill area and secure with tape.
  6. Install the rear washer hose (9) through the rubber conduit opening (12) in the right side of the instrument panel.
  7. Connect the rear washer hose (9) to the rear washer pump.

    8. Object Number: 853427 Size: SH
  8. Install the 2 push in retainers (2) to the rear of the headliner (1).
  9. Install the rear dome lamp. Refer to Dome Lamp Replacement .
  10. Install the right rear upper quarter trim panel. Refer to Quarter Upper Trim Panel Replacement .
  11. Install the right lower center pillar molding. Refer to Center Pillar Lower Trim Panel Replacement .
  12. Install the right hinge pillar trim panel. Refer to Body Hinge Pillar Trim Panel Replacement .
  13. Install the right wheelhouse panel. Refer to Wheelhouse Panel Replacement .