Circuit Description
The navigation antenna is connected to the vehicle communication interface module (VCIM) with an RG-174 coax cable. The VCIM polls the data from the navigation antenna once every second.
DTC Descriptor
This diagnostic procedure supports the following DTCs:
| • | DTC B2483 GPS Sensor Circuit |
| • | DTC B2484 GPS Sensor Circuit Open |
Conditions for Running the DTC
| • | The ignition must be in the RUN or ACC position. |
| • | The system voltage is at least 9.5 volts and no more than 15.5 volts. |
| • | All the above conditions are present for greater than one second. |
Conditions for Setting the DTC
| • | The VCIM does not detect a navigation signal. |
| • | All the above conditions are present for greater than one second. |
Action Taken When the DTC Sets
| • | The OnStar® status LED turns RED. |
| • | The OnStar® Call Center cannot locate the vehicle. |
Conditions for Clearing the DTC
| • | The VCIM detects the presence of a navigation antenna. |
| • | A history DTC clears after 50 malfunction-free ignition cycles. |
| • | The VCIM receives the clear DTC command from the scan tool. |
Step | Action | Values | Yes | No |
|---|---|---|---|---|
Schematic Reference: OnStar Schematics Connector End View Reference: Entertainment/Communication Connector End Views | ||||
1 | Did you perform the Diagnostic System Check - Vehicle? | -- | Go to Step 2 | |
2 |
Notice: Using a DMM to measure the resistance of the navigation antenna coax from the center conductor to the outer shield while the antenna is still connected will damage the navigation antenna.
Does the meter read out of limits? | -- | Go to Step 3 | Go to Step 4 |
3 | Measure the resistance of the navigation antenna coax center conductor from end to end. Does the resistance measure greater than the specified value? | 1 Ω | Go to Step 4 | Go to Step 5 |
4 | Replace the navigation antenna coax. Did you complete the replacement? | -- | Go to Step 7 | -- |
5 | Inspect for poor connections at the navigation antenna and the harness connector of the VCIM. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs . Did you find and correct the condition? | -- | Go to Step 7 | Go to Step 6 |
6 | Replace the navigation antenna. Refer to Cellular and Navigation Antenna Assembly Replacement . Is the repair complete? | -- | Go to Step 7 | -- |
7 |
Does the DTC reset? | -- | Go to Step 8 | System OK |
8 |
Important: Perform the OnStar® setup procedure.
Does the DTC reset? | -- | Go to Step 2 | -- |
