GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 Vibe - FWD 🢒 Suspension 🢒 Tire Pressure Monitoring 🢒 Tire Pressure Indicator Receiver Replacement

Removal Procedure
  1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  2. Remove the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.

    3. Object Number: 2013304 Size: SH
  3. Remove the bolt (2) from the tire pressure monitoring receiver (1).

    4. Object Number: 2013307 Size: SH
  4. Disconnect the connector (1) from the tire pressure monitoring receiver.
  5. Remove the tire pressure monitoring receiver from the vehicle.

Installation Procedure

    Object Number: 2013307 Size: SH
  1. Connect the connector (1) to the tire pressure monitoring receiver.

    2. Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 2013308 Size: SH
  2. Install the tire pressure monitoring receiver and the bolt (1). Engage the 2 tabs (2) into the holes.

    3. Tighten
    Tighten the bolt to 7.5 N·m (66 lb in).

  3. Install the rear quarter upper trim panel. Refer to Quarter Upper Trim Panel Replacement.
  4. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection.
  5. Configure the system. Refer to Tire Pressure Monitor System Configuration.