GM Service Manual Online
For 1990-2009 cars only
    • J 45059 Angle Meter
    • KM-470-B Angular Torque Gage

    Object Number: 1289681  Size: SH
  1. Coat the crankshaft bearings with engine oil.
  2. Install the upper crankshaft bearings into the engine block crankshaft journals.
  3. Install the lower crankshaft bearings into the crankshaft bearing caps.
  4. Install the crankshaft.
  5. Inspect the crankshaft end play with the crankshaft bearings installed.
  6. Check for permissible crankshaft end play. Refer to Engine Mechanical Specifications .

  7. Object Number: 1289682  Size: SH
  8. With the crankshaft mounted on the front and rear crankshaft bearings, check the middle crankshaft journal for permissible out-of-round (runout). Refer to Engine Mechanical Specifications .

  9. Object Number: 1289683  Size: SH

    Important: Grease the crankshaft journals and lubricate the crankshaft bearings slightly so that the plastic gaging thread does not tear when the crankshaft bearing caps are removed.

  10. Inspect all of the crankshaft bearing clearances using a commercially available plastic gaging (ductile plastic threads).
  11. Cut the plastic gaging threads to the length of the bearing width. Lay them axially between the crankshaft journals and the crankshaft bearings.

  12. Object Number: 1241797  Size: SH
  13. Install the crankshaft bearing caps.
  14. Notice: Refer to Fastener Notice in the Preface section.

  15. Install the crankshaft bearing cap bolts.
  16. Tighten
    Tighten the crankshaft bearing cap bolts to 50 N·m (37 lb ft). Using the J 45059 or KM-470-B  (1) tighten the crankshaft bearing cap bolts 45 degrees plus 15 degrees.


    Object Number: 1289685  Size: SH
  17. Remove the crankshaft bearing caps.
  18. Measure the width of the flattened plastic thread of the plastic gaging using the scale printed on the plastic gaging package.
  19. Inspect the bearing clearances for permissible tolerance ranges. Refer to Engine Mechanical Specifications .