GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2008 🢒 Wave 🢒 Safety and Security 🢒 Theft Deterrent 🢒 Remote Control Door Lock Receiver Replacement

Remote Control Door Lock Receiver Replacement Hatchback

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1252096 Size: SH

    Important: Remote keyless transmitters must be programmed when remote control module/receiver is replaced.

  1. Disconnect the negative battery cable.
  2. Remove the floor console. Refer to Front Floor Console Replacement .
  3. Disconnect the control module/receiver electrical connector.
  4. Slide the control module/receiver away from its mounting bracket.

Installation Procedure

    Object Number: 1252096 Size: SH
  1. Install the control module/receiver on its mounting bracket.
  2. Connect the control module/receiver electrical connector.
  3. Install the floor console. Refer to Front Floor Console Replacement .
  4. Connect the negative battery cable.
  5. Complete remote keyless transmitter programmming. Refer to Transmitter Programming

Remote Control Door Lock Receiver Replacement Notchback

Removal Procedure

    Caution: Refer to Battery Disconnect Caution in the Preface section.


    Object Number: 1859919 Size: SH

    Important: Remote keyless transmitters must be programmed when remote control module/receiver is replaced.

  1. Disconnect the negative battery cable.
  2. Separate the hood release cable from the hood latch release handle.
  3. Carefully pull the instrument panel under cover until the mounting clips are released and the instrument panel under the cover.
  4. Remove the bolts from the driver's side knee bolster.
  5. Disconnect the control module/receiver electrical connector.
  6. Slide the control module/receiver away from its mounting bracket.

Installation Procedure

    Object Number: 1859919 Size: SH
  1. Install the control module/receiver on its mounting bracket.
  2. Connect the control module/receiver electrical connector.

    3. Notice: Refer to Fastener Notice in the Preface section.

  3. Install the knee bolster with bolts.

    4. Tighten
    Tighten the driver's side knee bolster mounting bolts to 10 N m (89 lb in).

  4. Install the instrument panel under cover.
  5. Connect the hood release cable to the hood latch release handle.
  6. Install the screws.
  7. Connect the negative battery cable.
  8. Complete remote keyless transmitter programmming. Refer to Transmitter Programming