Tools Required

J 36796 Clip Removal Tool

1. Remove the accessory switch panel. Refer to Door Lock and Side Window Switch Replacement - Driver Side .



2. Remove the 2 trim panel retaining bolts.
3. Use the J 36796 in order to release the 9 trim panel fasteners from the door.
4. Remove the trim panel from the door.
5. Remove the inside door handle bezel. Refer to Door Handle Bezel Replacement .
6. Remove the outside rearview mirror (ORVM) switch, if equipped. Refer to Power Mirror Switch Replacement .

1. Install the ORVM switch, if equipped. Refer to Power Mirror Switch Replacement .
2. Install the inside door handle bezel. Refer to Door Handle Bezel Replacement .
3. Install the door trim panel to the door, as follows:

3.1.	Install the panel on the door by placing the upper flange into the belt seal lip.

3.2.	Install the rear upper retainer first.

3.3.	Install the forward upper retainer second.

3.4.	Install the remaining 7 retainers.

3.5.	Install the forward trim panel retaining bolt first. Do not tighten the bolt.

3.6.	Install the rearward trim panel retaining bolt second.

Notice: Refer to Fastener Notice in the Preface section.

3.7.	Tighten the 2 retaining bolts.

Tighten
Tighten the bolts to 10 N·m (88 lb in).

4. Install the accessory switch panel. Refer to Door Lock and Side Window Switch Replacement - Driver Side .